How to Choose Blackout Curtains That Really Block Light
The panel said one hundred percent blackout, it has four thousand reviews, and your bedroom still glows at half past five in the morning. The fabric itself is doing its job.

The panel said one hundred percent blackout, it has four thousand reviews, and your bedroom still glows at half past five in the morning. The fabric itself is doing its job. The light is coming in around it, down the sides of the window frame, over the top of the rod, and through the gap where two panels meet in the middle. That is the part no listing photo ever shows.
I have hung fourteen sets of blackout curtains in three different flats since 2021, including two sets I returned and one I gave away after a fortnight. What follows is what I check before I buy now, which specs on a listing are real and which are decoration, and the one popular piece of advice I think gets people to spend money on the wrong thing.
Where the light actually comes from
Put a torch outside your window at night and stand inside with the curtains shut. You will see the leaks immediately, and they are almost never through the cloth.
- Over the rod. A standard rod sits 10 to 15 cm off the wall. Light bounces over the top of the panel and onto the ceiling, which is the brightest and most annoying leak in a bedroom.
- Down the sides. If the panel ends at the edge of the frame, the gap between fabric and wall acts like a vertical strip light.
- The centre split. Two panels that just touch will separate slightly as the fabric settles.
- Under the hem. Less of a problem unless you have a low window or street lights below.
Grommet and eyelet tops are the worst offenders because the fabric has to sit in front of the rod, so there is a permanent channel of light at the top. Pencil pleat panels on a track, or a wrap-around rod with returns that curve back to the wall, close that channel. Changing from eyelet panels on a straight rod to pleated panels on a ceiling track did more for my sleep than any upgrade in fabric quality ever did, and the track cost about 22 dollars.
What the fabric labels actually mean
Three terms show up on nearly every bestselling listing, and only two of them tell you anything.
Three pass or triple pass means a foam coating applied in three layers on the back of the fabric, usually black foam sandwiched between two white ones. This is the real thing. It blocks close to all visible light, it is stiff, and it is the reason the curtain hangs heavy and dead rather than flowing.
Triple weave sounds similar and is not the same at all. It is three layers of woven polyester with a dark layer in the middle, no coating. It feels much nicer, drapes properly, and typically blocks 85 to 97 percent of light. In a bedroom facing a side street that is often plenty. Facing a car park with a sodium lamp, it is not.
Grams per square metre is the most honest number on the page when sellers bother to print it. Under 180 gsm is a light panel whatever else the title claims. Around 250 to 320 gsm is where the good triple weave sits. Coated three pass panels often come in at 350 gsm and up, and you feel every gram when you are standing on a chair hanging them.
| Construction | Light blocked | Typical price per panel | Works best for |
|---|---|---|---|
| Single layer with blackout print | 60 to 80 percent | 12 to 20 dollars | Living rooms, glare on a screen |
| Triple weave, no coating | 85 to 97 percent | 25 to 45 dollars | Most bedrooms, nurseries |
| Three pass foam coated | 98 to 100 percent | 35 to 70 dollars | Shift workers, bright street lights |
| Separate blackout liner behind existing curtains | 90 to 99 percent | 18 to 35 dollars | Keeping curtains you already like |
That last row gets skipped far too often. A detachable liner that hooks behind what you already own costs less than a new pair, keeps the look of the room, and can be taken down and washed separately. For rented flats with curtains already on the rail, it is usually the cheapest fix available.
The advice I disagree with: buy the heaviest panel you can
Almost every guide tells you to go for the thickest, highest gsm, fully coated option because more is better. I think that is wrong for most bedrooms, and I have the returned parcels to prove it.
Three pass coated fabric does three things people do not expect. It smells of plastic for a week or two, longer in a warm room. It cannot usually be machine washed, because the foam cracks and flakes off in the drum, so you are left with spot cleaning. And it holds moisture against cold glass, which in a poorly ventilated bedroom in winter gives you mould on the hem and the sill. I binned one pair for exactly that reason.
A 280 gsm triple weave that blocks 95 percent of light, paired with a proper track and a panel that overlaps the wall by 20 cm each side, gives a darker room than coated fabric hung badly, and you can wash it at 30 degrees. Spend the money on how it hangs before you spend it on how thick it is. The exception is genuine shift work, where you sleep through the middle of a bright day. Then take the coated fabric and live with the care instructions.
Measuring so the panel is big enough
Most disappointing blackout curtains are the right fabric in the wrong size. Four measurements matter.
Total width of both panels should come to about two times the width of your rod or track, and 2.5 times if you want proper gathered folds. For a 150 cm window you want roughly 300 cm of curtain. Buying two 140 cm panels for that window leaves fabric that sits almost flat and pulls away from the wall at the edges when shut.
Rod length should extend 15 to 20 cm past the frame on each side, which is more than most people fit. Mount the rod 10 to 15 cm above the frame as well, so the top of the fabric is above the glass rather than level with it.
Drop should take the hem to the floor or within a centimetre of it for a bedroom. A panel stopping at the sill leaves an open gap under it and the light pools on the floor. If the radiator is in the way, a sill length panel plus a liner is a compromise, not a solution, and you will still see a line of light.
Then check the return, meaning the distance from the end of the rod back to the wall. A wrap-around rod has that curve built in. On a straight rod, small magnetic or hook and loop strips cost a few dollars and pull the leading edge of the fabric flat against the wall. That trick is what finally killed the stripe of light on my bedroom wall. Headline numbers mislead in bedding too, which is why thread count tells you so little about bed sheets.
What goes wrong after the first month
The first week is not the test. Here is what shows up later, from the sets I kept and the ones I did not.
Creases from packaging on coated fabric mostly do not drop out, because you cannot iron the back and steam softens the foam. Give coated panels two weeks, then stop expecting flat.
Grommet rings on cheap panels are often painted metal over plastic. The paint wears where the ring slides and leaves grey marks on a pale rod. Rings pressed on both sides, not glued, last.
Colour fade is the quiet one. Dark panels on a south facing window lose depth along the leading edge within a year or two. White or oatmeal on the outward facing side is better, which is why good panels have a white reverse rather than matching colour throughout.
Noise reduction claims are the weakest part of every listing I have read. A heavy curtain takes some edge off echo inside the room. It does little against a motorbike outside, because sound comes through the glass and the frame. Treat noise figures as a bonus, not a reason to buy, and if the room temperature is the real complaint, a thermal lining and a draught check at the frame matter more than the curtain weight. Our notes on choosing a space heater by room size cover that side of a cold bedroom. More home picks sit in the home section.
Frequently asked questions
Do blackout curtains really block one hundred percent of light
The fabric in a three pass coated panel comes very close, often under 1 percent transmission. The window as a whole does not, because light passes around the panel. A room is only truly dark when the curtain is wider and taller than the opening and the edges are held against the wall.
Are blackout blinds better than curtains
A blind fitted inside the recess still leaves 5 to 10 mm of light down each side unless it runs in side channels. Blinds with channels are darker than any curtain and cost considerably more. Curtains are easier to fit wider than the opening, which is why they usually win on a normal budget.
Can you wash blackout curtains
Triple weave panels normally wash at 30 degrees and air dry. Foam coated panels usually say spot clean only, and the foam does crack in a machine. Check the care label before buying, not after the first spill.
How much should I pay for a decent pair
For a standard bedroom window, 55 to 90 dollars for the pair plus about 20 dollars for a proper track or wrap-around rod is the range where things start working properly. Under 30 dollars for a pair you are buying a single layer with a print on the back.
More in Home
Home
How to Choose a Tower Fan by Airflow and Noise
I bought a 42 inch tower fan in June because my desk sits under a west facing window and the room hits 29C by four in the...
Home
LED Bulb Labels: Lumens, Kelvin and What to Ignore
I bought eight bulbs for a flat in one order because they were the cheapest per unit and the listing said warm white.
Home
How to Choose a Weighted Blanket by Body Weight and Fill
You bought a weighted blanket because a thousand reviews promised deeper sleep, and now you wake up at 3 a.m.